Netcomm NP3640 Manuel d'utilisateur télécharger pdf (Page 30)

www.netcomm.com.au Rev. 1 - YML657

Page 30 NP3640 Fast Ethernet Mini Print Server User Guide

TCP/IP Tab

Selecting this tab will allow configuration for the TCP/IP network protocol. The basic options

are:

■ Dynamic IP Address (DHCP) - The IP address is obtained automatically, from a DHCP

Server on your network.

■ Fixed IP Address - You must enter the IP address, Subnet Mask, and Gateway Address.

■ IP Address - Select an unused IP address from the address range used on your LAN.

■ Subnet Mask - Use the same values as computers on your LAN (or on the same LAN

segment, if you have a Router).

■ Gateway - Use the same values as computers on your LAN (or on the same LAN segment,

if you have a Router).

Some Print Server models also support the Auto-IP function. If the Print Server is set to

Dynamic IP Address, but there's no DHCP server found on the network, the Print Server

will get an IP from the range of 169.254.1.1 ~ 169.254.254.254 automatically. In this case,

even though the Print Server was initialized with an Auto-IP, it will change to DHCP

whenever a DHCP server is detected.

The TCP session parameters should only be changed if advised to do so by your Network

Administrator or Print Server Technical Support.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 75 76

Pas de commentaire

Netcomm NP3640 Manuel d'utilisateur Page 30