Netcomm NTC-990 Manuel d'utilisateur télécharger pdf (Page 40)

Example:

Make sure NAT Configuration is enabled by clicking the ‘Enable’ radio button

Enter the information as appropriate

Click Save

NB:

If the “Incoming Port Range” specifies a single port (as above) then the destination port can be set to any

port.

If the “Incoming Port Range” specifies a range of port numbers then the “Destination Port Range” MUST be

the same as the “Incoming Port Range”.

Revision 1.55 NetComm Limited

March 2009

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 71 72

Pas de commentaire

Netcomm NTC-990 Manuel d'utilisateur Page 40